sears electric water heater manual

Use the wiring diagram supplied with or affixed to your water heater to answer specific questions whenever possible.
Start with the lowest level faucets and work up to the highest level faucets.
17 Be aware that a "good" heating element will read a very low value (between 10 and 20 ohms depending on wattage of the element and possibly read as 0 ohms depending on your meter).
Reply: Amity, I'm guessing either a wiring error or a bad thermostat.
It is important that all gasket material, filings, rust etc., be completely removed to reveal as smooth a surface as possible.One of these wires is usually connected to the thermostat associated it autocad land desktop 2009 full version (in these photos the thermostat is directly above it).Loose and broken connections are going to be a source of problems.42 If line voltage not found and the tank is cool, replace lower thermostat.Notice the lower left terminal of the thermostat.1 Check before leaks around the heating element before you continue.Stiebel Eltron is: Replace your hot water heater with an energy-efficient Stiebel Eltron Electric Tankless Water Heater today!



This electric water heater repair kit includes two electrodes and the upper and lower thermostats as well as replacement windows updateser 2.50 build 1002 indir plastic covers for vikings season 2 episode 5 kickass those devices.
Be sure to be sure the value displayed is really simply as reading the number displayed, and not the 1000 (kilo or K multiplier) or the 1,000,000 (meg M multiplier).
Click here to share your story.
See warranty for details.
Voltages present when power is on, are lethal.Water heaters can leak as a result of a failing tank - but also due to poorly fitted or soldered cold water supply pipe / hot water output pipe or a poor seal between tank opening and heating element.4, clear away any insulation blocking access or view of the controls (thermostat and high-temperature switch) and heating element.10, remove one wire from the heating element, it does not matter which.11 Secure the element into / on the opening in the tank with the bolts through the flange or threads on the element.Do not proceed unless power is proved off; otherwise damage to meter is likely and shock or burns is possible in the steps that follow.Once "zeroed this needle position on the dial is the "short circuit" or "zero ohms" indication for this range of this meter.